The Fluke 6062A is a synthesized RF signal generator delivering precise, stable signal generation from 10 kHz to 1000 MHz. Built for RF testing, calibration, and system development, it combines frequency accuracy of ±(frequency setting + 1 × 10⁻⁷), 1 Hz resolution, and output power spanning −127 dBm to +13 dBm. The instrument excels in demanding laboratory and field environments where signal purity and modulation flexibility are critical.
Technical Specifications
Frequency & Stability
• Range: 10 kHz to 1000 MHz
• Resolution: 1 Hz minimum
• Accuracy: ±(frequency setting + 1 × 10⁻⁷)
• Stability: <1 × 10⁻⁷ per hour (post 30-minute warm-up)
• Switching time: <100 ms between any two frequencies
Output Power
• Range: −127 dBm to +13 dBm
• Level accuracy: ±0.5 dB at 25°C (referenced to 50 MHz)
• Level resolution: 0.1 dB
• Flatness: ±0.5 dB across 10 MHz to 1000 MHz relative to 50 MHz
• Output impedance: 50 Ohms
• VSWR: 70 dB on/off ratio, 10 Hz to 10 kHz PRF, 1 µs to 100 ms pulse width
Signal Quality
• Harmonics: 0 dBm)
• Non-harmonic spurious: 0 dBm, excluding close-in)
• Phase noise: <−110 dBc/Hz at 1 GHz, 20 kHz offset (typical)
Interfaces & Control
• RF output: Type N female connector
• External modulation & trigger: BNC female inputs
• RS-232 service/control port for remote programming
Power & Physical
• Input: 100–120 VAC or 200–240 VAC, 50/60 Hz
• Consumption: <150 VA
• Dimensions: 5.25 in. H × 16.75 in. W × 15.0 in. D
• Weight: 30 lbs
– Key Features
• Synthesized architecture ensures exceptional frequency stability and 1 Hz minimum resolution
• Settling time <500 ms to within 0.5 dB and 100 Hz
• Broad modulation suite: AM, FM, and pulse modulation with internal and external sources
• Exceptionally low phase noise and harmonic content for signal integrity
– Typical Applications
• RF receiver and amplifier characterization
• Transmitter testing and development
• Component and subsystem validation
• Calibration of RF measurement equipment
• Communications system prototyping
– Compatibility & Integration
RS-232 interface enables remote operation and programming. Type N output connectors and BNC modulation inputs support standard laboratory RF configurations. 50 Ohm output impedance matches industry-standard test setups.
