The Kontron CP3-SVE-P200ACG is a 200 W AC-DC converter module engineered for CompactPCI systems and industrial electronic enclosures. It delivers multiple regulated output rails with hot-swap capability, current sharing across up to six parallel units, and redundant operation support. The unit accepts universal AC input (90–264 VAC, 47–63 Hz) and provides stable power in demanding temperature environments ranging from -40°C to +70°C, making it suitable for mission-critical embedded applications requiring high availability and thermal resilience.
## Technical Specifications
**Power Output**
• Nominal: 200 W @ 200 LFM; 250 W @ 400 LFM
• +5V / 40 A
• +3.3V / 40 A
• +12V / 5.5 A
• -12V / 1.5 A
**Input Specifications**
• Voltage: 90–264 VAC continuous
• Frequency: 47–63 Hz
• Inrush Current: 15 A peak (thermistor and electronic switch limited)
**Performance**
• Efficiency: 80% at full rated load, 115 VAC
• Hold-up Time: 20 ms
• Switching Frequency: 125–145 kHz
• Operating Temperature: -40°C to +70°C (50°C without derating)
**Electrical Protection**
• All outputs: short-circuit protected with automatic recovery
• Over-temperature shutdown with automatic reset
• Power Fail Signal (FAL#): TTL-compatible, open collector active low; triggers when any output drops below 90% nominal or input falls below 85 VAC
## Key Features
• Hot-swappable design for live insertion and removal
• Current sharing: ±10% accuracy across up to six parallel units on V1, V2, and V3 via single-wire tie
• Redundant operation capable
• Remote voltage sense on all three main rails plus sense return
• 47-pin Positronic male connector for direct backplane integration
• Peak inrush limiting prevents supply stress during soft start
## Typical Applications
• 3U CompactPCI chassis and subsystems
• Industrial control systems requiring distributed redundant power
• Telecommunications and data center infrastructure
• Mission-critical embedded systems with extended temperature operation
## Compatibility & Integration
Direct integration with Kontron CompactPCI backplanes via 47-pin Positronic connector. Supports panel-mount installation in 19″ rack enclosures. Multi-unit parallel configurations enable N+1 or N+M redundancy topologies with synchronized current distribution.
