The Teledyne LeCroy T3PM1100 is a single-phase digital power meter engineered for precise power analysis across DC to 100 kHz bandwidth. This instrument delivers ±0.05 % reading ±0.1 % level accuracy for voltage, current, and power measurements, making it essential for power supply validation, device optimization, and electrical system characterization. A 5-inch TFT-LCD display renders both numerical and waveform data simultaneously, with configurable modes ranging from general displays (two main + eight secondary parameters) to simplified four-parameter layouts.
Technical Specifications
Measurement Performance
• Bandwidth: DC, 0.1 Hz to 100 kHz
• ADC Resolution: 16-bit at 300 kHz sampling rate
• Voltage Ranges: 15 V, 30 V, 60 V, 150 V, 300 V, 600 V
• Current Ranges (Direct): 5 mA to 20 A across 12 steps
• Current Ranges (External Sensor): EXT 1 (2.5 V, 5 V, 10 V); EXT 2 (50 mV to 2 V)
• Minimum Current: 5 mA with 0.1 µA resolution; Power Resolution: 0.1 µW
• Crest Factor: Measures deformed waveforms up to CF 3; half-range measurement reaches CF 6
• Accuracy (V/I/P): ±0.05 % reading ±0.1 % level
Harmonic & Waveform Analysis
• 50th-order harmonic measurement per IEC 61000-4-7 (50/60 Hz)
• Display modes: numerical values and bar graphs
• Waveform capture: Voltage, Current, Power
• Derived parameters: frequency, effective/apparent/reactive power, power factor, crest factor, THD, maximum current ratio
– Key Features
• 25 relevant measurement parameters for comprehensive power profiling
• Automatic level-changing integration function for accelerated results
• Rich auxiliary measurement function set
• Multiple display modes optimize workflow efficiency
• 16-bit resolution at 300 kHz sampling supports high-fidelity harmonic analysis
– Typical Applications
• Power supply efficiency and regulation testing
• Power electronics characterization (switching mode supplies, motor drives)
• Harmonic compliance verification against IEC 61000-4-7
• Device power consumption profiling under dynamic load
• Three-phase system single-phase circuit analysis
– Compatibility & Integration
• Power Supply: 100–240 VAC, 50/60 Hz; Max 30 VA consumption
• Interfaces: USB (Device/Host), LAN, RS-232C
• Warming requirement: 30 minutes minimum for rated accuracy
