The Keysight M9804A is a PXIe Vector Network Analyzer module engineered for multiport RF test applications spanning 9 kHz to 20 GHz. Available in 2-, 4-, or 6-port configurations, it delivers PXI VNA performance with dynamic range, measurement speed, trace noise, and temperature stability optimized for production and R&D environments. Multiple modules cascade within a single PXIe chassis to create VNAs with up to 50 ports, each port operating synchronously with full multiport error correction. The M9804A inherits Keysight’s proven measurement science from the PNA, ENA, and Streamline Series platforms, ensuring consistent, repeatable results across complex test scenarios.
Technical Specifications
Frequency: 9 kHz to 20 GHz
Port Configurations: 2-, 4-, or 6-port options; cascadable to 50 ports
Output Power: 10 dBm
Harmonics: −25 dBc (typical)
Measurement Speed: 1.3 ms at 201 points, 1 sweep
Power Dissipation: 37.8 W maximum (2-port)
Module Temperature Range: 37–50 °C (2-port), 40–53 °C (4-port), 43–56 °C (6-port)
Supply Voltages: +3.3 V, +5 V, +12 V, −12 V
Port Connector: 3.5 mm female
– Key Features
• Fully synchronous multiport measurement with N-port error correction for accurate characterization of complex devices
• Fast multiport calibration via electronic calibration (ECal) modules
• Advanced measurement modes including spectrum analysis, noise figure, and vector signal analysis (optional hardware/software)
• Operates within Keysight PXIe chassis (M9010A, M9019A, M9046A)
• Supports 2×8, 4×4, or 1×8 PXIe system slot link configurations
– Typical Applications
• Multiport component and subsystem characterization
• Production test of RF amplifiers, filters, and coupled networks
• Multi-site antenna and phased-array measurements
• Noise figure and mixer characterization
– Compatibility & Integration
Requires Keysight PXIe chassis, PXIe embedded controller (M903xA series or equivalent), and Keysight IO Libraries Suite 2018 Update 1 or later. Operating environment: ambient temperature −10 °C to 55 °C, stable for 60 minutes before turn-on; chassis ambient 0–55 °C. Instrument must be on 60 minutes within calibration cycle before measurement.
