The Anritsu MS2723C is a handheld spectrum analyzer covering 9 kHz to 13 GHz, engineered for field spectrum monitoring, interference analysis, and wireless communication system testing. It delivers dynamic range exceeding 104 dB in 1 Hz resolution bandwidth and displayed average noise level of –160 dBm (preamp ON). Sweep speeds reach 100× faster than previous generations across three modes: Fast, Performance, and No FFT. Frequency accuracy of ±25 ppb with GPS and amplitude accuracy of ±0.7 dB typical (±1.25 dB maximum) support demanding RF measurements from DANL to +30 dBm.
## Technical Specifications
• **Frequency Range:** 9 kHz to 13 GHz
• **Resolution Bandwidth (RBW):** 1 Hz to 10 MHz
• **Video Bandwidth (VBW):** 1 Hz to 10 MHz
• **Dynamic Range:** >104 dB (1 Hz RBW)
• **DANL:** –160 dBm (1 Hz RBW, preamp ON)
• **Phase Noise:** –100 dBc/Hz @ 10 kHz offset at 1 GHz
• **Frequency Accuracy:** ±25 ppb (GPS ON)
• **Amplitude Accuracy:** ±0.7 dB typical; ±1.25 dB maximum (15°C to 35°C)
• **Power Measurement Range:** DANL to +30 dBm
• **Power Requirements:** 8 to 18 Vdc via USB
• **Battery Life:** Approximately 2.5 hours (Li-Ion)
• **Warm-up Time:** <5 minutes
## Key Features
• Trace modes: Normal, Max Hold, Min Hold, Average with configurable averaging
• Six markers with delta capability or single reference with six delta markers
• Up to 40 segment limit lines with automated envelope creation
• Save-on-Event trigger for trace capture at limit line crossing or sweep completion
• Channel power measurement: Occupied Bandwidth, Channel Power, ACPR
• Optional Interference Analysis includes Spectrogram, Signal Strength, RSSI, and on-screen Interference Mapping
• Optional Modulation Analysis covers RF Spectrum, Audio Spectrum, Audio Waveform, and Demodulation Summary
• Optional 3GPP/3GPP2 signal analyzers for LTE, TD-LTE, GSM/EDGE, W-CDMA/HSPA+, CDMA, and EV-DO
• Optional IEEE 802.16 analyzers for Fixed and Mobile WiMAX
• Optional Channel Scanner (1 to 2 channels)
• Optional GPS receiver for enhanced frequency accuracy and data tagging
## Interfaces & Integration
• Data Transfer: Ethernet/USB
• External Reference: BNC female, 50 Ω input (–10 to +10 dBm); 10 MHz output
• External Trigger: BNC female, 50 Ω (±5 VDC maximum)
• IF Output: 140 MHz on BNC female, 50 Ω
• Headset Jack: 2.5 mm, 3-wire
• Optional High Accuracy Power Meter requires external power sensor
