The Teledyne LeCroy T3DSO1102 is a two-channel digital oscilloscope delivering 100 MHz bandwidth and 1 GSa/s real-time sampling for signal acquisition and analysis across electronics design, development, testing, and debugging. Its 28 Mpts memory depth captures extended signal events, enabling detailed investigation of complex waveforms on a 7-inch color LCD display.
Technical Specifications
Vertical System
• Input Coupling: DC, AC, GND
• Voltage Scales: 1 mV/div to 10 V/div
• Vertical Resolution: 8 bits
• DC Gain Accuracy: ±3%
• Bandwidth Limit: Selectable 20 MHz
• Input Impedance: 1 MΩ ±2% || 15 pF ±5 pF; 50 Ω ±2%
Horizontal System
• Timebase Ranges: 5 ns/div to 100 s/div
• Pre-trigger View: Configurable
• Roll Mode: Supported
Acquisition & Display
• Real-Time Sampling: Up to 1 GSa/s per channel
• Memory Depth: 28 Mpts (standard)
• Waveform Capture Rate: Up to 10,000 waveforms/sec
• Display: 800 × 480 pixel color LCD, 7-inch diagonal
Trigger System
• Modes: Auto, Normal, Single
• Types: Edge, Pulse Width, Video, Line-Rate, Pattern, Duration, Rise/Fall Time, Nth Edge
• Trigger Holdoff: Configurable
Measurement & Analysis
• Automatic Measurements: Over 30 types (Vpp, Vmax, Vmin, Vavg, Vrms, Frequency, Period, Pulse Width, Rise Time, Fall Time, Duty Cycle)
• Waveform Math: Add, Subtract, Multiply, Divide, FFT
• FFT Resolution: Up to 1 Mpts
• Cursor Measurements: Manual, Track, Auto
Connectivity & Control
• USB Host: Waveform and setup storage/retrieval
• USB Device: Remote control and PC data transfer
• LAN (RJ-45): Network connectivity and remote operation
• Trigger Output: BNC connector
Power & Environment
• Input Voltage: 100–240 VAC, 50/60 Hz
• Power Consumption: < 30 W
• Operating Temperature: 0°C to +40°C
• Operating Humidity: ≤ 80% RH
– Key Features
• Dual-channel architecture supports simultaneous two-signal acquisition
• Flexible trigger system with eight distinct trigger types handles complex signal events
• Over 30 automated measurements accelerate analysis workflows
• Selectable 20 MHz bandwidth limiting reduces noise in high-frequency environments
• Dual input impedance (1 MΩ and 50 Ω) accommodates various probe types
• Fast waveform capture at 10,000 waveforms/sec reveals rare events
• USB and LAN interfaces enable local and remote operation
– Typical Applications
Digital and analog circuit debugging, signal integrity verification, power supply ripple analysis, timing characterization, video signal testing, embedded system development, general-purpose troubleshooting in electronics labs and manufacturing environments.
– Compatibility & Integration
USB connectivity supports direct waveform transfer and setup management with external storage devices. LAN interface permits integration into automated test environments and remote monitoring scenarios. BNC trigger output facilitates synchronization with external equipment.
