The Amplifier Research LN1000BM3 is a low-noise preamplifier module engineered for sensitive receiver applications and laboratory signal conditioning across a broad frequency spectrum. Operating from 10 kHz to 1000 MHz, the unit delivers 30 dB minimum gain with ±1.5 dB flatness, making it ideal for amplifying weak signals ahead of power amplifiers or improving receiver sensitivity. Noise figure of 3.5 dB typical (4.5 dB maximum, 2–1000 MHz) and +21 dBm IP3 ensure minimal signal degradation in demanding measurement environments.
Technical Specifications
• Frequency Range: 10 kHz – 1000 MHz
• Gain: 30 dB minimum; ±1.5 dB flatness
• Noise Figure: 3.5 dB typical, 4.5 dB maximum (2–1000 MHz)
• Output Power: +11 dBm at <1 dB gain compression
• Input for Rated Output: –18 dBm maximum
• Third Order Intercept Point (IP3): +21 dBm typical
• Harmonic Distortion: –20 dBc maximum at +11 dBm output
• Input Impedance: 50 ohms, VSWR 2.5:1 maximum
• Output Impedance: 50 ohms, VSWR 2.0:1 maximum
• Mismatch Tolerance: Operates without damage, foldback, or oscillation with any magnitude and phase of source and load impedance
• Modulation Support: Faithfully reproduces AM, FM, and pulse modulation
– Key Features
• Automatic input voltage selection: 100–240 VAC, 50/60 Hz
• IEC 320 type AC connector on rear panel
• Broadband operation with instantaneous bandwidth
• 50 ohm RF interface compatibility
• Dimensions: 26.0 × 11.7 × 21.6 cm; 4.5 kg
– Typical Applications
• Pre-amplification of low-level signals for power amplifier drive
• Receiver sensitivity enhancement
• EMC precompliance and radiated emissions testing
• General laboratory signal conditioning
– Compatibility & Integration
Compliant with CISPR, CISPR 11, CISPR 14-1, CISPR 14-2, and CISPR 16-1 standards. RF connector configuration varies by model specification; confirmation recommended for exact connector type.
