The Anritsu MN4697C is a 4-port test set designed for vector network analysis across RF and microwave frequencies. It features V connectors (1.85 mm) and operates from 70 kHz to 70 GHz, enabling multi-port device and circuit characterization with exceptional dynamic range and low trace noise. The test set integrates with Anritsu’s VectorStar MS464xA/B series 2-port Vector Network Analyzers to extend measurement capability beyond standard 2-port configurations.
## Technical Specifications
**Frequency Range:** 70 kHz to 70 GHz (operational to 40 kHz)
**Connectors:** V connectors (1.85 mm)
**Performance Characteristics:**
• Test Port Power: Maximum rated power typical from 2.4 GHz to 2.7 GHz
• Noise Floor: Measured at 10 Hz IF bandwidth, no averaging, –10 dBm power setting, RMS. Leakage correction applied below 200 MHz
• System Dynamic Range: Calculated as difference between maximum test port power and noise floor
• Receiver 0.1 dB Compression: Port power level where response may compress >0.1 dB relative to normalization level (0.17 dB, <300 kHz); 10 Hz IFBW applied; characteristic performance
• Receiver Dynamic Range: Difference between maximum receiver input level for 0.1 dB compression and noise floor; characteristic performance
**Operating Conditions:**
• Warm-up time: 90 minutes (ON state)
• Temperature range: 25 °C ± 5 °C
• Error-corrected specifications: 23 °C ± 3 °C, <1 °C variation from calibration temperature
## Key Features
• 4-port architecture for multi-port vector network measurements
• Low insertion loss test set design
• Extended frequency coverage to 70 GHz
• High receiver dynamic range and low noise floor
• Leakage correction capability for sub-200 MHz operation
## Compatibility & Integration
The MN4697C requires an Anritsu VectorStar MS464xA/B series 2-port VNA (not included) with Option 051 (Direct Access Loops). Compatible models include MS4645A/B and MS4647A/B.
