The Keysight/Agilent/HP E1340A is a VXI-based arbitrary function generator replacement board delivering signal generation across DC to 15 MHz with 12-bit resolution and 42 MSa/s sampling. This B-size, single-slot module combines arbitrary waveform generation with standard waveforms (sine, square, ramp, triangle, sin(x)/x, noise, haversine), linear frequency sweep, FSK modulation, and waveform hopping for comprehensive signal conditioning in test systems.
Technical Specifications
Waveform Generation
• Arbitrary waveforms with 16 kSa memory, segmentable into 4, 8, or 16 kSa blocks
• Up to 4 waveforms in active memory
• Burst mode: 1 to 65,534 cycles or continuous
• Maximum sine frequency: 15 MHz
• Square/ramp/triangle maximum: 1 MHz
• Square wave risetime: 25 ns (typical); jitter: 24 ns
Output Performance
• Amplitude: 10.2 Vp-p maximum into 50 Ω (extendable to 20 Vp-p with external amplifier)
• Output impedance: 50 Ω ± 1%
• DC amplitude accuracy: ± 2.7% of full scale
• AC amplitude accuracy: ± 0.43 dB
• Offset range: ± 5.11 V into 50 Ω
• Sine THD: −60 dB (0–1 MHz), −63 dB (0.1–1 MHz)
• Sine flatness: 0.2 dB to 10 MHz; 0.5 dB to 15 MHz
Frequency Control
• Linear sweep: 0.01 Hz to 15 MHz
• Sweep rate: 0.4 Hz/s to 2.6 MHz/s
• FSK rate: up to 3 kHz
• 42.9 MHz timebase (50 ppm) or external clock input
Integration
• VXI register-based device
• External inputs: clock, burst, gate, waveform hop, FSK
• Supported drivers: I-SCPI Win 3.1, I-SCPI Series 700, C-SCPI LynxOS, C-SCPI Series 700, HP Panel Drivers
• Firmware: Command Module revision A.06 or later
– Key Features
• 12-bit DAC with fine (11-bit) and coarse (0 dB/20 dB) attenuation control
• Configurable waveform looping and modulation via FSK
• Low jitter (24 ns) for timing-sensitive applications
• Multiple input gates for external signal control
– Typical Applications
Component and subsystem testing in VXI chassis, signal conditioning for receiver validation, frequency sweep characterization, and modulated waveform generation for RF and analog circuit verification.
– Compatibility & Integration
Designed for VXI mainframes. Register-based command architecture supports standard SCPI instrument drivers across Windows, LynxOS, and dedicated HP panel control environments. External clock and modulation inputs enable synchronization with test sequencing and stimulus switching.
