The National Instruments PCI-MIO-16-1 is a multifunction data acquisition board designed for PCI-based systems using E-Series technology. It delivers 12-bit analog input and output, digital I/O, and counter/timer functions for data logging, process control, and automated testing applications.
Technical Specifications
Analog Inputs
• 16 single-ended or 8 differential channels (software-selectable per channel)
• 12-bit resolution
• Maximum sampling rate: 1.25 MS/s
• Input ranges: ±0.05 to ±10 V with 15 selectable ranges
• DC coupling, NRSE/RSE/DIFF modes supported
Analog Outputs
• 2 channels at 12-bit resolution
• Maximum output rate: 1 MS/s
• Output range: ±10 V
Digital I/O
• 8 TTL/CMOS-compatible lines at 5 V
Counter/Timers
• 2 channels, 24-bit resolution
• Maximum frequency: 20 MHz
• Base clocks: 20 MHz and 100 kHz at ±0.01% accuracy
Triggering
Analog and digital trigger support with configurable analog input or post-gain PGIA signal selection.
Physical
• 68-pin male 0.050 D-type connector
• Dimensions: 6.9 × 4.2 inches
• Weight: 4.1 oz
• Operating temperature: 0 to 55 °C
• Storage temperature: –20 to 70 °C
– Key Features
Onboard software-based self-calibration eliminates potentiometer adjustment. The board requires 15 minutes warm-up time and annual calibration intervals. Dual-mode analog triggering allows direct input or post-gain signal routing for flexible measurement control.
– Typical Applications
Data logging, process control, and automated test systems benefit from this card’s multi-range input capability—particularly when acquiring low-level signals below 50 mV alongside standard-range measurements.
– Compatibility & Integration
PCI bus interface with software support for LabWindows/CVI and Measurement Studio for Visual Basic and Visual Studio .NET. NI-DAQmx driver support available; terminal naming may differ in NI-DAQmx versus Traditional NI-DAQ (Legacy) implementations.
