The Rigol DSA710 is a spectrum analyzer covering 100 kHz to 1 GHz, purpose-built for RF testing and signal characterization across communications, EMI compliance, and component verification workflows. Its all-digital IF architecture delivers stable, repeatable measurements with typical DANL of -130 dBm and phase noise below -80 dBc/Hz at 10 kHz offset. An 8-inch WVGA display (800×480 pixels) presents spectrum traces with high clarity. Automated functions—Auto Tune, Auto Range, Auto Scale, and Auto Couple—accelerate measurement setup and reduce manual parameter entry. Resolution bandwidth spans 100 Hz to 1 MHz, enabling both narrowband signal isolation and broadband survey work. Level measurement uncertainty stays below 1.5 dB across the operating range.
Technical Specifications
• Frequency Range: 100 kHz to 1 GHz
• Displayed Average Noise Level (DANL): Typically -130 dBm; -155 dBm/Hz (typ.)
• Phase Noise: < -80 dBc/Hz at 10 kHz offset
• Resolution Bandwidth: 100 Hz to 1 MHz minimum
• Level Measurement Uncertainty: < 1.5 dB
• Display: 8-inch WVGA, 800×480 pixels
• IF Architecture: All-Digital
• Input Protection: Active above +25 dBm (PA off, ≥10 MHz)
• Form Factor: Compact, lightweight design
– Key Features
• Integrated preamplifier for enhanced sensitivity
• N-type and BNC female input connectors
• LAN (LXI) and USB Host/Device interfaces; GPIB optional
• IEEE 488.2 command compatibility
• Filesystem and USB stick support for waveform logging
• 2FSK modulation measurement and analysis option (2FSK-DSA)
• EMI Filter and Quasi-Peak Detector kit available
• Advanced Measurement Functions optional
• Integrated help documentation
– Compatibility & Integration
• Compatible with S1210 EMI Pre-compliance Software
• Supports Near Field Probes (NFP-3)
• EMI-DSA800 option for EMI PreCompliance measurements
• Optional PC software control
• User Manual, Datasheet, Quick Start Guide, and Programming Guide included
