The Teledyne LeCroy RP2060 is a 2 GHz power/voltage rail probe purpose-built for power integrity analysis on digital power management circuits. It delivers precise measurement of ripple, noise, and transient events across voltage regulators, point-of-load converters, and low-dropout regulators in embedded systems. Minimal loading on the DUT combined with low inherent noise enables engineers to characterize low-voltage DC power rails with confidence.
Technical Specifications
Bandwidth & Risetime
• Bandwidth: 2 GHz
• Risetime: 220 ps
Dynamic Range & Noise
• Dynamic Range: ±800 mV
• Probe Noise (typical): 110 µVrms
• Input Impedance (DC): 50 kΩ
• Input Impedance (high frequency): Low impedance
Attenuation & Offsets
• Attenuation: 1.2x nominal
• Offset Range: ±60 V
• Maximum Input Voltage (hand-held): 60 Vdc referenced to ground
• Non-Destructive Voltage: ±100 V
– Key Features
• ProBus interface compatibility with Teledyne LeCroy offset amplifier
• DC 50 Ω coupling to oscilloscope
• Multiple interconnect options: solder-in leads (three 4 GHz MCX to leads at 18 cm), three U.FL ultra-miniature coaxial cables (3 GHz, 8 cm), and 0.9 m SMA-to-MCX extension cable
• Browser tip available as optional accessory (RP4000-BROWSER) with 500 MHz bandwidth, selectable 1x/10x/20x attenuation
• Supplied in soft storage case with foam insert
– Typical Applications
• Digital power management characterization
• Voltage regulator module (VRM) analysis
• Point-of-load switching regulator evaluation
• Low-dropout regulator assessment
• Power rail ripple and transient measurements in complete embedded systems
– Compatibility & Integration
Recommended for Teledyne LeCroy HDO and HD oscilloscopes. Compatible with WaveSurfer 3000z/4000HD High Definition and WaveRunner 9000 models. Operates 0 °C to 50 °C; rated to 3,000 m altitude maximum.
