The Power Ten P62B-20100 is a 2 kW DC power supply engineered for industrial and commercial applications requiring stable, regulated output. This unit delivers 0–20 VDC at 0–100 A with tight line and load regulation, making it suitable for test benches, manufacturing systems, and critical electronic equipment.
Technical Specifications
Output Rating
• Voltage: 0–20 VDC
• Current: 0–100 A
• Power: 2000 W
Output Quality
• Ripple and noise: 75 mV peak-to-peak
• Voltage regulation (line/load): 0.1% of maximum rated output
• Current regulation: 0.5% of maximum rated output
• Stability: ±0.05% of set point per 8 hours (after 30 min warm-up at fixed line, load, and temperature)
• Transient response: 30% current step recovers to ±2% of set voltage within 10 msec
Temperature Performance
• Operating: 0 to +50°C, no derating
• Storage: −20 to +70°C
• Voltage coefficient: 0.02%/°C of rated output
• Current coefficient: 0.03%/°C of rated output
Input Power
• Supply: Single-phase 200–240 VAC, 50/60 Hz
• Input current (typical @ 208 VAC, 2 kW): 10 A
• Cooling: Internal fans
– Key Features
• Over voltage protection with adjustable limit and front-panel preset
• Current limit with foldback characteristic
• Over temperature and brown-out protection
• Turn-on surge limiting and slow-start circuit
• LCD metering for voltage and current; LED mode and fault indicators
• Remote sensing terminals for voltage measurement at load
• Contact closure and TTL/CMOS switching control via rear panel
• Output voltage and current monitoring; remote OVP limit adjustment
• Master/slave, series, and parallel operation capability
• Optional IEEE 488.2 and RS-232 remote programming (SCPI protocol)
– Operational Capabilities
The P62B-20100 supports multi-unit configurations for distributed power delivery and synchronized operation. Front-panel controls and LCD displays enable direct adjustment and monitoring. Remote interfaces accommodate automated test systems and facility-level integration.
– Compatibility & Integration
Input/output connectors and remote interface pinouts are detailed in the P62 Series Operation Manual. Connector specifications for 2–3 kW models are provided in the manual’s Table 2-1.
