The Teledyne LeCroy ZD200 is a 200 MHz active differential probe engineered for high-fidelity measurement of differential signals in automotive, serial data, and general circuit analysis applications. It delivers 1.75 ns risetime with minimal loading through its 1 MOhm input resistance and 3.5 pF input capacitance. The probe accepts differential signals up to ±20 V (DC + peak AC) while rejecting common-mode voltages to ±60 V, making it suitable for wide dynamic range testing. Its 10x attenuation and small, low-mass probe head enable accurate measurements in confined spaces without signal degradation.
The ZD200 integrates directly with Teledyne LeCroy oscilloscopes via ProBus interface, eliminating the need for external power supplies and enabling automatic sensitivity and offset calibration. Specially designed lead and tip accessories maintain signal integrity and suppress peaking across a range of probing configurations. Probe tip socket accommodates 0.025 inch square pins, and closely spaced differential inputs support direct connection to header pins, test points, and probe leads.
Technical Specifications
• Bandwidth (Warranted): 200 MHz
• Risetime (10–90% Typical): 1.75 ns
• Probe Attenuation: 10x nominal
• Input Resistance: 1 MOhm
• Input Capacitance: 3.5 pF
• Differential Input Voltage Range: ±20 V (DC + peak AC)
• Common-Mode Voltage Range: ±60 V
• Operating Temperature: 5° to 40° C
• Operating Humidity: Up to 90% RH at ≤31° C; decreasing linearly to 50% RH at 40° C
• Altitude: Up to 10,000 ft (3,048 m)
– Key Features
• Active differential architecture for excellent signal fidelity and low loading
• ProBus power delivery—no external supply or batteries required
• Comprehensive accessory suite: straight tips, hook clips, Y leadsets, micro IC clips, micro-grabbers, extension leads (5 cm and 10 cm), dual pin sets (12.8 mm and 16.8 mm)
• Compact probe head for access to confined measurement points
– Compatibility & Integration
Compatible with Teledyne LeCroy WaveSurfer, WaveRunner, WavePro, and WaveMaster series oscilloscopes running MAUI firmware 6.4.1.x or later. Automatic calibration via ProBus eliminates manual probe setup.
